Hypertec FastPrint Multiprotocol Ethernet/Fast Ethernet Pri Instrukcja Użytkownika Pobierz pdf (Strona 16)

Index

To mount the HyperNet Fastprint with the front panel facing up (and the

printer port connectors facing down), set the two mounting screws at the

lower-left and upper-right corners of a rectangle as shown below (actual size):

110 mm

70 mm

When setting the screws into the wall or partition, leave about 3 mm (

in)

between the head of each screw and the wall surface. Then place the

HyperNet Fastprint so that the mounting sockets on the bottom of its case fit

over the two screws. Press the case gently toward the wall and slide the case

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Brak uwag

Hypertec FastPrint Multiprotocol Ethernet/Fast Ethernet Pri Instrukcja Użytkownika Strona 16