Hypertec HYNTR70002 Instrukcja Użytkownika Strona 1

HyperNetToken Ring PC CardHYNTR70002User GuideInformation in this document is subject to change without notice. Allrights reserved. All brand names

10. Windows for Workgroups will now copy the appropriate drivers to the hard diskand modify the config.sys, autoexec.bat,system.ini and protocol.ini f

7. To setup the software, select Configure.8. From the Configure menu, select LAN adapters and Protocols.9. From the menu, select Configure.10. Select

HelpAccess help information.Viewing Configuration ParametersTo view system configuration parameters, select System Config from the View menu. Theconfi

ExplanationPossible problem in the card configuration.Recommended Actions Check that the PCMCIA Adapter card is inserted into the PCMCIA slot. If a

ExplanationAs aboveRecommended ActionsAs aboveNetwork Driver TroubleshootingWhen an error message is received from one of the Network Operating System

adapter in the slot ready for you to use next time.To remove the STP connection from the card, gently squeeze the plastic clips located onthe side of

Direct EnablersWeight:2.1 oz, 62 gr. (including STP connector)PCMCIA Card Size:Length - 3.37"(85 mm)Width - 2.13"(54 mm)Thickness - 0.197&qu

Filter (TRMF).

does o c ude se v ce o ep d ge esu g o cc de , d s s e , suse, buseor non-Hypertec modification of the product.Additional components installed by the

European Community (EC) Electromagnetic CompatibilityDirective.This equipment had been tested and found to comply with the protection requirements ofE

PCMCIA compatibility and Plug and Play features are assured with full support of allmajor Card and Socket Services vendors. Compatibility with all maj

If you do not have each of these items, contact your supplier before proceeding furtherStatic Electricity WarningStatic electricity is accumulated nat

adapter is a Type II PCMCIA card, which is compatible with any Type II PCMCIA slot. Ifyour computer has more than one slot, you may insert the adapte

Socket services. When Card and Socket Services are present, the drivers will automaticallyconfigure themselves to work with it. When Card and Socket s

in “Custom” mode. These procedures are the same as for modifying configurationparameters and running diagnostic tests after the initial installation,

screen indicates the tests status.Running Tests1. While the tests run, the Close button on this screen changes to a Stop button. Tostop the tests, pre

The following sections present instructions for installing specific Network OperatingSystem drivers. For other Network Operating Systems, please follo